DOME NOZZLES

The done type nozzles on the following pages are used with hot melt or cold adhesives. They allow a single gun to be used to apply multiple lines, or a radial pattern of dots. They are mounted to the gun with a threaded lock ring. There are four types listed, one of which will fit your gun.

The "IN LINE" type applies up to 6 parallel lines from a standard nozzle. The lines need not be equally spaced. The spacing of the lines when they reach the work is determined by the height of the gun nozzle, and the angles of the drilled holes. Note that you can order dome nozzles with almost any set of angles to suit your needs, and are not confined to listed stock sizes. Ask for our help in determining hole angles for your exact needs.

The "RADIAL" type applies a circular pattern of dots onto work that is stationary, and again a selection of angles, and gun heights determine the size of the pattern.

Stainless Steel is generally used with cold adhesives and brass with hot melts.

dome_nozzle2.gif (1298 bytes) dome_nozzle1.gif (14655 bytes)

This actual size chart shows the theoretical location where a dot of adhesive, ejected from a nozzle at a specific angle and distance will meet the substrate.

It assumes the adhesive travels in a straight line.

NOZZLE TYPE AND DESCRIPTION
LARGE DIAMETER DOME, INLINE
Click to see this type of nozzle.
LARGE DIAMETER DOME, RADIAL
Click to see this type of nozzle.
MEDIUM LENGTH DOME, INLINE
Click to see this type of nozzle.
MEDIUM LENGTH DOME, RADIAL
Click to see this type of nozzle.
SHORT LENGTH DOME, INLINE
Click to see this type of nozzle.
SHORT LENGTH DOME, RADIAL
Click to see this type of nozzle.
MEDIUM LENGTH, SMALL BASE DOME, INLINE
Click to see this type of nozzle.
MEDIUM LENGTH, SMALL BASE DOME, RADIAL
Click to see this type of nozzle.

NOZZLETECH INC., 3208C EAST COLONIAL DR., ORLANDO, FL.,32803
1-800-544-2969 1-407-839-1500
 Fax 1-407-426-2025
Copyright NOZZLETECH, INC. 1998, 2004 all rights reserved.